ISSUE 34

 Return to the BUILD


“In this issue you will fit another part to the chassis of your DeLorean and add a reservoir by following these step-by-step instructions.”

 

Contents


Parts

Materials: The Chassis Front Upper is metal, but the Reservoir is plastic.

Magazine

  • Drive Time: Model Instructions
  • The Further Adventures of Micheal J.: Fox’s roles after Back to the Future
  • A Time Traveler’s Guide: Marc McClure

Build


The Chassis Front Upper

Step 1

Fit the (washer fluid) Reservoir to the Chassis Front Upper.

The Reservoir has two pegs with holes underneath it. The smaller hole aligns over the small pin on the Chassis Front Upper:

Step 2

Turn this assembly over and secure the Reservoir into place with one (1) FP screw:

Step 3

Place the Chassis Front Upper over front of the car chassis.

I recommend fitting the front section over the posts of the radiator inlet first, then lower the rear into place:

Then, secure these rear holes with four (4) DM screws.

This is your friendly reminder to try using 3-in-One Oil on all screws going into metal:

Step 4

Secure the front of the Chassis Front Upper to the top of the radiator inlet with two (2) FP screws:

Thoughts


Nothing crazy in this issue, so it did not take long at all. Unfortunately, that is it for this month’s delivery. However, this is the point in the build where I installed The Power Mod from Model Modz, so check that out. Until next time!

Next Up


 Issue 35 – Frame: Front Wheel Arches

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.